Reaper Rig Field Setup: Step-by-Step Guide

Quick answer

Set up your Reaper Rig for field use by adjusting the harness, balancing your load, and adding the Warfighter Expansion Kit for full load-bearing capacity.

Step-by-step Reaper Rig setup

1. Adjust the harness: Loosen all straps, put on the rig, then tighten the shoulder and side straps so the rig sits high on your chest without restricting breathing. Check that it doesn't shift when you raise your arms. The rig should stay put during a quick shoulder roll.
2. Balance your load: Place heavier items (magazines, tools) close to your centerline and distribute weight evenly left and right. Avoid stacking everything on one side. Re-check balance after adding new pouches.
3. Attach the Warfighter Wings: Mount the wings to the sides of the Reaper Rig using the internal or external mounting points. Use the MOLLE columns to attach additional pouches or gear. Ensure the wings are securely locked and don't flop during movement.
4. Route retention and quick release: Run any retention cords or quick-release tabs so they are accessible with either hand. Test the release mechanism to ensure it operates smoothly under tension. Practice releasing and re-securing the rig several times before field use.

Gear that helps

• Warfighter™ Expansion Kit for Reaper™ Rig: The Warfighter™ Expansion Kit includes two semi-stiffened wings with 4 MOLLE columns each, and supports internal and external mounting. This gives you extra mounting space and distributes heavier loads more comfortably across your chest.