Six Pack Hanger Pouch Setup for Plate Carrier

Quick answer

Mount the Six Pack Hanger Pouch to your plate carrier's front flap or cummerbund using the integrated MOLLE straps, then adjust the height so it sits above your beltline without restricting movement.

How to set up the Six Pack Hanger Pouch on a plate carrier

1. 1. Attach the top MOLLE straps: Weave the two top MOLLE straps through the webbing on your plate carrier's front flap or cummerbund, starting from the back and threading forward. Pull them snug but not tight enough to distort the carrier fabric. Common mistake: weaving only one strap. Always use both for even load distribution.
2. 2. Secure the side straps: Route the side straps through the adjacent MOLLE loops or around the carrier edge, depending on your setup. Fasten them so the pouch sits flat against the carrier without sagging. Checkpoint: the pouch should not swing side to side when you move.
3. 3. Adjust the vertical position: Slide the pouch up or down before fully tightening. The ideal height is just above your beltline—high enough to clear your belt but low enough to reach easily. Tighten all straps evenly. Common mistake: mounting too low causes the pouch to flap against your legs. Aim for a 1–2 inch gap above your belt.
4. 4. Test movement and access: Perform a few squats, bends, and torso twists. The pouch should stay in place without shifting. Reach for the contents to confirm you can access them without unclipping the carrier. If the pouch shifts, re-tighten the side straps or move it one row higher.

Product facts

• Six Pack™ Hanger Pouch: The Six Pack Hanger Pouch includes a Fanny Pack Conversion Strap and was validated downrange in real missions to eliminate issues with over-long hanger pouches. You can convert it to a standalone fanny pack, and the design prevents the pouch from dangling below your beltline during movement.